版權說明:本文檔由用戶提供并上傳,收益歸屬內容提供方,若內容存在侵權,請進行舉報或認領
文檔簡介
1、Heating systems with PLC and frequency controlSalah Abdallah, Riyad Abu-Mallouh *Department of Mechanical and Industrial Engineering, Applied Science University, Amman 11931, Jordana r t i c l e i n f oArticle history:Av
2、ailable online 18 July 2008Keywords:Heat treatmentPLC controlFrequency controlTemperinga b s t r a c tIn this work, medium capacity controlled heating system is designed and constructed. The programmingmethod of control
3、of heating process is achieved by means of integrated programmable logic controller(PLC) and frequency inverter (FI). The PLC main function is to determine the required temperatures levelsand the related time intervals o
4、f the heating hold time in the furnace. FI is used to control the dynamicchange of temperature between various operating points. The designed system shows the capability forfull control of temperature from zero to maximu
5、m for any required range of time in case of increasing ordecreasing the temperature. All variables of the system will be changed gradually until reaching theirneeded working points.An experimental study was performed to
6、investigate the effect of tempering temperature and temperingtime on hardness and fatigue resistance of 0.4% carbon steel. It was found that increasing tempering tem-perature above 550 ?C or tempering time decreases the
7、hardness of the material. It was also found thatthere is a maximum number of cycles to which the specimen can survive what ever the applied load was.? 2008 Elsevier Ltd. All rights reserved.1. IntroductionHeat treatment
8、is the controlled heating and cooling of metals to alter their physical and mechanical properties without changing the product shape. Heat treatment is often associated with increas- ing the strength of material, but it
9、can also be used to alter certain manufacturability objectives such as improve machining, improve formability, and restore ductility after a cold working operation. Thus it is a very enabling process that can not only he
10、lp other man- ufacturing process, but can also improve product performance by increasing strength or other desirable characteristics [1,2]. A new single-switch parallel resonant converter for induction heating was introd
11、uced in [3]. The circuit consists of an input LC- filter, a bridge rectifier and only one controlled power switch. The switch operates in a soft communication mode and serves as a high frequency generator. A voltage-fed
12、resonant LCL inverter with phase shift control was presented in [4]. It was seen that the control strategy offered advantages in the megahertz operating region, where a constant switching frequency is required. The inver
13、ter steady state opera- tion is analyzed using fundamental frequency analyses. A cost-effective high efficiency inverter with phase-shifted pulse modulation scheme was proposed for medium power (5–30) kW induction heatin
14、g applications is discussed in [5]. The pro- posed inverter accomplishes soft switching operation over a wide power regulation range. The actual power conversion efficiency reached was 96.7%. A control method of reducing
15、 the size of the dc-link capacitors of a converter–inverter system was presented in [6]. The main idea is to utilize the inverter operation status in the current control of the converter. This control strategy is effecti
16、ve in regulating the dc-voltage level. Even the dc-link capacitor is arbitrarily small and the load varies abruptly. In [7] a method was proposed to accurately predict the mini- mum required temperature recovery consider
17、ing repeatability and accuracy of the leak detector by investigating the relation be- tween temperature recovery time and theoretical thermal time constant for various test volumes and applied pressures using PLC system.
18、 In [8] a methodology was demonstrated to design a PLC pro- gram that organized the relation between the physical inputs and outputs of the pumping tools in manufacturing systems. In [9] an experimental study was perform
19、ed to investigate the effect of using two axes tracking with PLC control on the solar en- ergy collected. The two axes tracking surface showed better perfor- mance with an increase in the collected energy up to 41% compa
20、red to the fixed surface. The PLC main function is to control the required temperature levels and the related time intervals of the heating hold time in the furnace [10]. Frequency inverter is used to control the dynamic
21、 change of temperature between various operating points [11,12].0196-8904/$ - see front matter ? 2008 Elsevier Ltd. All rights reserved.doi:10.1016/j.enconman.2007.11.017* Corresponding author. Tel.: +962 5 3740026.E-mai
22、l addresses: Salahabdalah_1964@yahoo.com, Salahabdalah_1964@hotmail.com (S. Abdallah), mallouh@maktoob.com (R. Abu-Mallouh).Energy Conversion and Management 49 (2008) 3356–3361Contents lists available at ScienceDirectEne
23、rgy Conversion and Managementjournal homepage: www.elsevier.com/locate/enconmanwhere Ed is the rectified voltage at the output of converter, Rd is the active resistance of coil and id is the coil current, iu is the input
24、 cur-rent of the inverter and ic the current of the condenser.3.2. Modeling of the furnaceThe right hand side of Fig. 2 illustrates a furnace consisting of a three phase heater in a room. The three phase heater emits hea
25、t at a rate of q1 and the room loses heat at a rate of q2.q1 ¼ 3kh ? iu ð5Þwhere Kh is the heater coefficient. Assuming that the air in the room is at a uniform temperature T and that there is no heat stor
26、age in the walls of the room, we can derive an equation describing the time rate of change in room temperature.q1 ? q2 ¼ codTdt ð6Þwhere Co is the thermal capacity of the air in the room. If the temperatur
27、e inside the room is T and that outside the room is To, thenq2 ¼ T ? To Ro ð7Þwhere Ro is the resistivity of the walls. Substituting for q2 givesq1 ? T ? To Ro ¼ codTdtHenceRocodTdt þ T ¼ Ro
28、q1 þ To ð8Þ4. Experimentation and results4.1. Testing the control system performanceIn order to test the ability of the designed control system to per- form the desired temperature control properly, succes
29、sive heat treatment experiments were performed and their results are de- scribed as follows.Fig. 3 shows the input frequency vs. time and Fig. 4 shows the temperature vs. time for the two specimens 1 and 2 where this pro
30、cess represent a heat-treatment process carried out with ramp- ing function only (i.e. the furnace and frequency inverter only are used), the holding time in this case was counted off from the mo- ment the furnace is act
31、uated (form room temperature). That is why the graph starts at 20 ?C and then temperature rise up using the ramp up function in the frequency inverter on a range of time forprogramControllerABCV1V4V2V5V3V6V7 V8 V9V12 V11
32、 V10C+-LdCiruit 1 Ciruit 2q2T Toid iuicq1uiuThree phase heaterFurnaceFig. 2. Principle circuit of frequency controlled three phase heater.Personal Computer PLCAnalog UnitFrequency InverterParameter UnitThree Phase Heater
33、Program to control the slope of temperature TProgram to cntrol the temperature levelFig. 1. Block diagram of PLC and frequency controlled heating system.3358 S. Abdallah, R. Abu-Mallouh / Energy Conversion and Managem
溫馨提示
- 1. 本站所有資源如無特殊說明,都需要本地電腦安裝OFFICE2007和PDF閱讀器。圖紙軟件為CAD,CAXA,PROE,UG,SolidWorks等.壓縮文件請下載最新的WinRAR軟件解壓。
- 2. 本站的文檔不包含任何第三方提供的附件圖紙等,如果需要附件,請聯系上傳者。文件的所有權益歸上傳用戶所有。
- 3. 本站RAR壓縮包中若帶圖紙,網頁內容里面會有圖紙預覽,若沒有圖紙預覽就沒有圖紙。
- 4. 未經權益所有人同意不得將文件中的內容挪作商業或盈利用途。
- 5. 眾賞文庫僅提供信息存儲空間,僅對用戶上傳內容的表現方式做保護處理,對用戶上傳分享的文檔內容本身不做任何修改或編輯,并不能對任何下載內容負責。
- 6. 下載文件中如有侵權或不適當內容,請與我們聯系,我們立即糾正。
- 7. 本站不保證下載資源的準確性、安全性和完整性, 同時也不承擔用戶因使用這些下載資源對自己和他人造成任何形式的傷害或損失。
最新文檔
- [雙語翻譯]plc外文翻譯--基于plc變頻控制的加熱系統
- [雙語翻譯]plc外文翻譯--基于plc變頻控制的加熱系統中英全
- [雙語翻譯]plc外文翻譯--plc變頻控制的水泵系統(英文)
- 2008年PLC外文翻譯--基于PLC變頻控制的加熱系統(英文).PDF
- [雙語翻譯]plc外文翻譯--plc變頻控制的水泵系統
- 2008年plc外文翻譯--基于plc變頻控制的加熱系統
- 2008年PLC外文翻譯--基于PLC變頻控制的加熱系統.DOCX
- [雙語翻譯]plc外文翻譯--plc變頻控制的水泵系統中英全
- 外文翻譯--基于plc與頻率控制的加熱系統(英文)
- 2009年PLC外文翻譯--PLC變頻控制的水泵系統(英文).PDF
- 外文翻譯--基于plc與頻率控制的加熱系統
- 外文翻譯--基于plc與頻率控制的加熱系統
- 2009年plc外文翻譯--plc變頻控制的水泵系統
- 2009年PLC外文翻譯--PLC變頻控制的水泵系統.DOCX
- 外文翻譯--基于plc與頻率控制的加熱系統(譯文)
- 外文翻譯譯文--基于PLC與頻率控制的加熱系統.doc
- [雙語翻譯]--plc交通燈外文翻譯---基于plc的交通信號燈控制系統設計(英文)
- 外文翻譯譯文--基于PLC與頻率控制的加熱系統.doc
- 外文翻譯---plc變頻調速的網絡反饋系統的實現(英文)
- 外文翻譯--plc控制系統
評論
0/150
提交評論